Recent content by aeriel

sour patch yummy

Thank you all,, I mean to hop back on here and update but sometimes life gets in the way. Great news tho!! I threw caution to the wind and did a factory reset of my ground station followed by fresh calbation/rebinding of camera and obviously controller..presto..good as new.

welcome mate..nor cal here..woot woot.. Yes i have some awesome advise for ya.. You see those big brown things with green leafy extremities? those are called trees..stay away fom the trees,...ha!!

No sir I did not.,.but Im going to now..ty

yessurrrr..im on it..

Darn I thought I was special for a minute..

Ok..here we go. Did as suggested and purchased the boards from yuneec skins. Installed them, yes both sides and still same same same spinny camera on its axis. So now im thinkin somethings purty messed up and about to just purchase a new cam. But before I do, lll entertain a few more...

trade? new skyview fpv?

MY HERO!! BIG HUGS

ok well, disconnected the board as suggested, picture is no longer red but cam still spinning by itself...suggestions??

PERFECT!! Thank you mucho, you read my mind !! My next question was going to be if you could give me a starting point . Ill do what you suggested now and jump back in here and advise my findings. Thanks again for helping me get this sorted out. Stay tuned

Thanks for chiming in , the purpose of naming off the s1 s2 s forth positions was to try and give as much info as possible , Ill answer your questions in order asked: video feed is only redish while viewing it thru ground station, no cam dies not tilt normal but like I said it spins non stop...