Recent content by bennieg

It will still not recognize the H. It appears that Windows 10 does not support com ports or even virtual com ports. It is looking for a Com1 port Does anyone have a work around for this?

I have to say the instructions that come with the H are very limited. I did download a better set from the Yuneec site. I got the the GUI set and got hung up. I updated the firmware on my H and then connected to the computer but it is not recognizing the GUI. Does anyone have any suggestions? I...

I think I figured it out. The message is apparently referring to the wifi between the ST16 and the H. Anyway it is working and updated. Apparently when I created a new model in the setup it did not take so I did it again and everything is fine so far. There is a wifi feature in the PAD and I...

I just got my H in the other day. I downloaded the ST16 and H updates to my SD card. I was able to update the ST16 but the H will not connect to the ST16. I keep getting a "wifi not connected" when I select Update under the H. After I power the H up a RED light comes on on the CG03 and then it...