Recent content by Blaster

Hi Texas Willie.........hope your having great flying weather!! Say, regarding your Q on those Powerextra Lipos. I also have considered those but I usually try to "google" for any reviews of parts, or lipo batteries and have come to find out that those are the "low end" lipos in that they may...

Webbster...........sorry I could not (due to video size) embed my video related to your previous experienced motor issue. It appears you may have "erroneously" soldered wrong wire to wrong connection point on one of the ESC board. ALSO.....I would encourage you to perform (immediately after...

Ok bheath..........I'm going to "bail" you out of your "minor wiring gimbal" concern..........please see this you tube video. Learning is part of out "drone maintenance" growth and development. Take care!! Hope the "link" opens up correctly............:) Some of these issues can be a DIY...

Hey Jafo...........sorry bout delay in my reply, .........YES, just discovered you're "resolution" was "right on target" regarding false/positive thing. Just got off phone w/Yuneec and verified procedure..........you are good Jafo. (Thanks again) On a side note.......couldn't immediately locate...

Hello Alan (agrafton)......could you tell me "where" you purchased the "cable" to connect it from your computer or laptop to the "wiring harness" that hangs out of the battery insertion port, I have just installed a "brand new ESC" and would like to perform "esc id test". Yuneec has a video on...

Hey guys.......hope you are having a great flying Summer. Just a quick one here regarding use of the ESC ID Software from YUNEEC web-site. After downloading the software.......my McAfee software stated: "WHOA sure you wanna go there"? Stated the software has a virus. I'm certain the Yuneec...

Hey Pharkas, by now you may have already "bumped into" the Part 107 Chapter 5.10.2 section "Determining Altitude". Hope you've revisited this section, and discovered that it will offer you "clarity" on your inquiry of March 01, 2016. Happy Altimeter Flying......:)

Hello Ignus......Blaster here, say....assuming you have not corrected the issue to today's date (11-06-16) those replacements I'm sure can be a "challenge". Double check the "white pin port connectors" in that they need to be "seated" correctly, I would check to see if the "male pins" are...