Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Carlos Castellanos

  1. Interconnection module of the battery

    Interconnection module of the battery

    Detail of the interconnection module of the battery.
  2. Wiring to Main card

    Wiring to Main card

    After removing the battery compartment, the wiring is exposed to the control cards of the motors.
  3. Main card detail

    Main card detail

    Main card detail
  4. Arms of the Gimbal crashed

    Arms of the Gimbal crashed

    Damage suffered by the aluminum arms of the gimbal
  5. My Crashed Typhoon

    My Crashed Typhoon

    Photo album of the damage suffered by my Q500 4k, the casing was changed and the drone was fully operational, for professional reasons I do not share the details of the repair.
  6. CGO-3 after crash

    CGO-3 after crash

    In this state the CGO-3 camera and the gimbal remained after a fall of approximately 50 feet in height.
  7. Motor Controller

    Motor Controller

    To change the housing of the Q500 drone, it is necessary to desolder the cables that go from the motors to the controller card of each one.
  8. Case Crashed

    Case Crashed

    In this photo you can see the damage suffered by the drone housing, the central body with the battery compartment and the wiring.
  9. Communications module

    Communications module

    This is the communication module of the drone, we must take special care with the antennas and their location to avoid interference and possible communication failures with the ST-10.
  10. Main Card

    Main Card

    Detail of the main board of the Q500, in the left foreground the USB connection port for firmware update.
  11. Upper housing

    Upper housing

    Here you see the damage suffered by the upper casing
See more