Recent content by Chinchillanuts

Good idea. All kinds of unexpected things can happen. Been there, rebuilt that

That's correct, commonly known as "burn in time". It can happen with any microelectronic circuit board. At least that's what I was told when my new flat screen mysteriously bought the farm :(

Thanks, you too! First flight back. Glad I made the effort :)

You are correct. I had a brain stall when I was replacing the escs and had some wires crossed. Red, blue, black, how hard could it have been. The summary to this is...pay attention. The one rear led is still different on start up but it flies! A bit of a favor toward one side in flight but I'll...

Thanks Steve, I had done that and everything shows green. I did it again now to see if I missed anything, same result. The only one spinning in the correct direction is the right rear. The only thing that might give me a hint that something isn't right is that the LR light stays solid red while...

I replaced the air frame and now I have a solid red light on one motor and 3 of the props are spinning clockwise. I'm assuming it might not fly well like this :D. I connected the GUI and I have all green check marks but when I test rotate motors, 3 are spinning in one direction. Any suggestions...

I succeeded at updating Q500+ and I've run into a hang up trying to update ST10+ controller. I have the update software (still zipped as directed) on the (pre-blank) mini sd card. My computer shows it exists, the ST10+ controller can't seem to find it. Suggestions?

I was going to ask a question but I see yours is 4 months old with no answer...lol, I'll keep searching