Recent content by dan met

Finally a 2 axis gimbal (come on we are on 2019) !!!! they should start with that instead of adding useless gestures features.

here are some mods and the dismantled mantis Q for anyone who want to knows what it mades of

Hi everyone.Im asking if anyone has dismantled a crashed Mantis Q because i need the internal firmware (located in the hidden internal sd card on the main board).I believe that its where the pixhawk board looking for informations for the booting and initialisation sessions.Yes you have another...

yeah you re right and i did what you ve mentionned with sd card and so on but same issue either with euro or standard firmwares!I ve heard that my H is from an earlier version which is more sensitive about electromagnetical issues than the newer version so it will give me the same issue everytime

you re right! just tested it and it had a wrong behavior so i went back to an ealier update

I know that but this is not the case.I have a orange and purple flashing light .Its binded already

I dis calibrage again and again si il gonna contact them...thks

Hi everyone i have some issues after my last typhoon H update.a compass warning message like in the photo joined is appearing while im flying!Never had any issue like that before the latest update and im flying in the same location everytime without any problem.Anyone with the same issue? thanks

Good deal

Hi Steve im located in Guadeloupe a french West indies Island pretty close To St Marteen.

my issue is that i ve found websites where i can buy the part but unfortunatly they don t ship it to my island!even yuneec europe can t do anything except asking me to send it back to them while its not under warranty anymore which means expensive repair and lot of waiting time to get back to me...

i ve got you Jeff and you re absolutly right!i've lost the 3ways switch by trying to tightening too much.Then solder comes up with the electronic board while i thought it was just a screw lose and tightening needs.

hi everybody i want to change my ST16 buttons functions because of some issues with the 3 positions switch on the right top side of the controller(the one which controls the flights mods) and put these function on the obstacle avoidance 3 positions switch).I mean i want to reprogramming my st16...

Perfect landing here! A bit risky but you did it well

I ve seen somebody putting a trick by changing a few things in an st16 file and then insert it and you ll have the map on a waypoint mode for the H480 (its not the 920 s waypoint mod).i ve tried it a few tims and it worked perfectly for me.in the other hand we have the awesome Uav toolbox which...