Recent content by Derek

lol I mean to say " wow this is a really well thought out and thorough checklist... didn't catch that

Wow this is a really well thought and thorough out check list, I think I might start using this before I fly my H!

I was following along with a video that was done by CAPTAIN DRONE on YouTube about how to update my typhoon H's firmware and I had inserted the SD card into the gimbal with only the drone firmware and it gave me that message I typed above, I just didn't know what went wrong so I asked in the...

okay awesome ill try it and if I have any issues ill let you know

okay ill try it, and I already have the tablet connected to my wifi at home so what do I do after I try to update the drone and it tells me the file cannot be found?

Well I opened the SD card file up and the firmware for the drone's name is "TyphoonH_Ver3.04_A.bin and the type just says BIN File. Is that what you were asking for?

I am trying to update the firmware on the drone, I've already completed the firmware on the controller I just cant get the firmware updated on the drone. I downloaded the firmware from the Yuneec website and transferred it to the SD card, then I put that into the cameras SD slot then I power on...

Yeah, fortunately I figured that out after looking around it for a few minutes. I just gone done talking to Pat and he helped me figure out how to get the anti vibration balls through the bottom part, I pinched the lip of it and pushed it through then just rotated it till it went all the way...

How do I remove the top part of the gimbal? I don't see where I can lift it from the entire gimbal, it seems to be securely connected with the bottom piece.

So if this clears things up the rubber pieces that are out are connected to the top part of the gimbal but not to the bottom piece that it should be. So how do I make the lip small enough to fit through the hole of the bottom part?

ok thanks man

Okay, so how do I put the lips back into the hole? I have no clue of how to even do that.

I don't even see how to go about putting the two that are out, back in. The flat part that is above the hole has a larger diameter than the actual hole it should be in, so how should I put that back into the hole itself?

I see the two that have a washer holding them in place.. but the other two diagonal pieces are completely out and I can see it clearly, do you know how to make them go through the holes?

I just received my typhoon H and I took off the gimbal to look at it and noticed that the back left and front right rubber pieces ( not sure what they are called ) towards the top are not all the way in on the gimbal and was wondering if that is supposed to be like that or not, I have no clue, I...