I just mod the 4hawks lately.before eveything works fine just only the range i got ,so i decided to check it again might have some wires loosen ,when i put it back together and turn it on it beeps and the “yuneec” wont appear black screen only
Help,
I open my st10 to double check my antenna mod,after i close it again i turn on my transmitter i dont see anything on the screen at all.any help please
Thanks
Jafo,
Where can i find the external mod for the q500?i already mod the cgo3 camera.one last try moding the drone itself..
I had done moding;
St10+ with 4hawks
Cgo3 camera mod from carolina dronz
I only got 1000ft after mod.not satisfied
Yes j2 is slugginsh in my hardware.all buttons turn green.but j2 is jumping 60-75 wont go 100 ocassionally.do i need to change sticks from vertigo?i did spray contact cleaner befre .
Did compass calibration several times in any location.when in the ground no yellow flash when its up in the air purple/white flashes(which means i have a good gps lock), then after slowly climb up yellow flash for 1 second only.yellow flash occasionally only
It happens when i start to climb up after i calibrate flashes but occasionally.i dont get it why.do i need to worry if compass failure/fly away could happen because of this?i fly but line of sight only i wont risk going far because of this flash.have you called yuneec on this?