Recent content by DREAMWASH

I've installed the new September Firmware. Rebound my bird to my ST16. Recalibrated the Compass. I've tested the bird, it flies just fine. But I tried pressing the left or right on the bottom right controller to start a cruise control and it doesn't budge. What might I be missing?

Yuneec should really license this technology and place on their website!

Stupid Me, been using your online editor and didn't donate! Fixed that today! :)

The CCC DOES NOT control the Gimbal YAW!! It does control the 'Drone Yaw' and 'Gimbal Tilt' when PAN MODE is set to 'FOLLOW' so yes you'll get what you are trying to accomplish but be sure to have the PAN MODE set correctly and use the yaw of the bird itself not the Gimbal!

Go to GPS Calibration / Accelerometer Calibrate and make sure it zero's out your altitude before taking off and running the CCC

No golf course is going to allow this. He could get in the way of a golf ball or worse the golf ball could take out a propeller

Altitude is calibrated back to 0ft when you select 'accelerometer calibrate'. I'm not confused. This has been the ONLY way I've found to zero out the altitude when I start a new flight in a new location.

Its about 3 seconds to dial in my speed. I prefer 11mph so two full UP trigger the speed I want. If someone wants 8.5 they could do a FULL UP, 33% light tap up/up/up.

Really wish people would not post 'false information'. Here is the FACTS - I just tested them Pushing FULL UP/DOWN makes wide changes, we are talking 5.5mph and 11mph CCC speed While I was at 11mph (10.6-11.0) CCC I was able to feather the left stick down about 33% for a split second, this...

Zayne, did you purchase with an American Express? They will cover the cost under their buyer protection you get for all new purchases... Purchase Protection - Frequently Asked Questions - American Express® Purchase Protection can help protect your purchases for up to 90 days from the date of...

When you select start, the drone flies to waypoint 1 and stops. Now press up one time it will fly at a slow speed (speed listed on left side of screen). Press up on left stick a second time it will fly the route at 10mph. If thats too fast a light tap down will decrease speed, another light...

Click GPS calibration in right side of ST16 screen Select Accelerometer calibration I do this before every takeoff and make sure altitude on left side of ST16 is under 6"

1) speed single up on left stick starts out slow, second up goes to 10mph, now tap down quickly to bring it to 8, 6, 4 mph.. you can see mph in left side of ST16 real-time 2) calibrate altitude before running waypoints. Must when using low altitudes because weather pressure changes in 10-15min...

Further details and videos showing examples are on my CCC thread. Curved Cable Cam - Ideas for best video footage Basically you need use pan the drone not the camera, pan switch in Follow mode, and lots of waypoints create smoother action

I use 100 grit sand paper, just a little off the hub, about 30 seconds of sanding on the backside of the heavy blade You balance the blade first so that it will lay horizontal without floating downward Now you place the prop vertical, so the hubs are now on left/right side, if it floats blades...