Recent content by FoxFoto

I just checked and everything is the same with the exception of the Autopilot which is: V1.25 Is there a way for me to update this and or is it necessary? Thanks for the help.

I have spent quite a bit of time trying to locate US firmware updates for my ST16 and Typhoon H. I am currently running what originally was installed in both when new. Can someone please point me in the right direction. Thanks!

Hoping someone can help. Flew the other day for the first time in a long while and experienced some glitches. Wanted to update the firmware on both the ST16 and the Typhoon H. I am having trouble finding a place on the Yuneec site that will allow me to do this. I have the original firmware since...

In reading the posts here I am going to assume this is what happened to me on my first flight with the H. Unboxed it, set it all up, initialized everything and after lifting off a few feet it took off across a road and into a stand of trees getting stuck in branches two stories up. At 63 I was...

Update- took the system into a hobby shop about an hour away and mounted the camera from another drone on and it functioned fine. I am sure now the problem is a damaged wire from the initial impact the popped the camera off from the mount. Thanks again for everyone's help...

The update it keeps telling me it is doing has to do with autopilot and landing gear improvements. Updates and installs but apparently is never recognized because it will keep trying to do the same one. Would like to be able to uninstall and reinstall the gimbal if that is possible as that might...

Thanks Ray, have had the camera off and checked all connections, no matter what I do the camera will not move manually via the switches, knobs and slider on the TX. If a calibration is attempted there is no movement of the camera. It centers on start up or if I physically move it with my hand it...

This is what my screen looks like. I did rebind the camera but still no movement other than when the unit boots up or I move it off from the center position. Controls have zero effect over it.

Thanks for that info. I still do not have any gimbal control. There is power to it because it will center from any position when the drone powers up. If I physically move it off center by hand, it returns to center. The camera also takes photos and video so that is not an issue. I did check the...

Both camera switches are up. No movement of the camera by slider on the side or rotary knob. It will center itself on boot up no matter what direction it is facing. The card I have says the color led, whether green, purple etc has to stay solid for there to be a GPS lock. It said blinking...

Did a brief test hop in the backyard, basically lifted off and hovered and flew around a bit in angle mode. I cannot get the GPS to stay locked and it looses it shortly after everything is initialized and seems to be working ok. I tried maybe a half dozen times. Will connect, show I am in the...

Thanks, think I might just do that. Rain tomorrow then gone for a week after. Will let you know how it goes if I can get out...

Ok, not sure what the beeping was for but it sure helped me locate the aircraft un in the tree. The transmitter was beeping after it went into the trees telling me that it had lost motor power which makes sense since they all stopped turning. As for the credibility issue. someone explained the...

Sounds like that was probably the culprit then. I will update the firmware for both drone and the ST16 and make sure everything is done correctly this time. Looks like I just took a stupid pill and did not do enough research prior to my attempting the first flight. My desire for getting my...