Recent content by gn298595

Yes it was...under about 2 feet of water. I found it because the lights were still on.

Just recently (July 4th) I was filming my cousin skiing using the watch me/follow me on my Q500. Well I should have flown higher..pesky tress get right in the way. Despite t all, replaced 1 motor and she flies perfectly again.

Wanted to give a final update. I tried all cleaning suggestions. It changed nothing. While using the motor test in the GUI, the B motor would start and stop intermittently. I decided against swapping motors or ESC's with other motors as I did not want to creat any issues that were not there...

That's actually a great idea. I'll try swapping the motors to see what happens. Can't hurt.

Had a crash this weekend while using follow me Watch Me. Just clipped the top of a tree (thought I was high enough). Drone crashed down through the tree and into the water (following me on my boat). I was able to find the drone since the lights were still on (in the water for about 5 minutes)...

Looks to be around 7.5mm best I can get to it

So I just powered it up. Two things. 1. The camera started rocking back and forth until I physically stopped it with my hand, then it kept itself turned left at 45 degrees or so. While powered off, the camera moves freely without issue. I also rocked the drone forward, backward and side to side...

I will do that in a short bit, my wife is using the room where my drone is located. Thank you for this help, anything is greatly appreciated. I love my drone and love to fly, just frustrated right now.

I have a Typhoon Q500 4k with a CGO3 Camera

It is not 90 degrees left, probably slightly more than 45, maybe 60 to 70 degrees. Nothing has been pulled out, there does not appear to be any damage on the surface. Other than it being pointed sideways, yes, it seems to handle the stabilization fine.

Yes, the camera does respond the the manual control, it just sits facing left the entire time. Makes no beeping sounds other than the normal sounds upon initial load.

I apologize if this is in the wrong thread, I am new to this forum. I have the Q500 4k and had a small crash( drop of about 3 feet. I broke the tips off of two blades, otherwise everything seemed fine, until I got my replacement blades installed and went to fly. The issue is actually with my...