Recent content by jwc

Thank you for your response. I will resume my quest tomorrow.

Thank you so much for the suggestion. I also, reset the st10 to factory settings a second time to start over. I also started over with the q500 verification and I verified all the connections in the battery compartment are connected. This time I was able to get further than before. It was...

I just read a post that I should try resetting my ST10+, so I did. These are the current settings listed: Android version 4.0.3 Kernel version 3.0.8 Build number st10_v01b31c Hardware version P1.4 The camera will come up to bind, but the drone will not.

Please don't ignore this post. My original post was moved and it took me a bit to find out where the replies were. I am not a bot. I have been reading dozens of suggestions and following all of them and yes, one of the suggestions had a link to a virus which delayed me even further. Inside...

My Typhoon Q500 4K will not bind to my Yuneec ST 10+ and I have a warning about clicking on the links in some of the replies in here. One of them and I can't get back to it to screen shot, is a click here to a link for a McAfee virus. I spent 30 minutes repairing Microsoft Edge after it would...