Recent content by Nateb006

The GUI will show the change but it will not actually make the change. Currently the only way around it is to update to the latest firmware and then back off the autopilot to 1.29. This will give you all the latest and greatest but still allow for flights higher than 400ft. From what I...

The fix will end up being with the autopilot. I've had the same issue and after two calls over three weeks and no call back with a fix I decided to keep my autopilot rolled back to 1.29. Everything else is updated to the latest. Runs fine. I have a feeling Yuneec is either going to really...

Awesome, thanks!

@Tuna , Is there a way to set up a Cable cam where I have complete control the the camera throughout the mission? In other words, I'll set the way points for it to follow but will have control over the angle and pitch of the gimbal through the mission?

So far they are denying the issue. There will be a fairly heavy amount of them sold if it can't be changed. I'll go back to flying my inspire every day. I bought the Yuneec for smaller jobs and to take some load off the other bird. But because of what I do and where I'm at, the height limit...

@Tuna I'm checking this out right now. This is exactly the type of growth we need with the Yuneec. If there was a way to see a live map view while flying and snapping photos I'd be set. Giant hats off though to you for creating this and when you're set up and ready to start charging (which...

I actually contacted Yuneec today in regards to the 400ft issue. They claim that even if sent a link they will not read anything from a forum. They do things on a case by case basis and are supposedly looking into the issue. I inspect towers and ended up down for a week because I couldn't go...

It was actually posted as a fix in another thread on the forum. Only the autopilot has been set back to 1.29. I do tower inspections and need to be over 400 feet on a weekly basis. According to Yuneec as of today they know nothing about this issue and although I originally called them two...

From what I understand it was an issue with the autopilot. I have not spoken with Yuneec yet to see if they resolved it, I simply downgraded to 1.29 for now and it fixed the issue. The controller still runs the latest.

Awesome news! Thanks.

No issues with the update, however the H is now limited to 400 feet. When entering the GUI to change the setting it will accept the change however the H will not respond to the change and even though shown as changed it will not go above 400 ft. For most, I'm sure this is no problem. I...

I can confirm that with the latest firmware you cannot change the height. The GUI will show the change but the typhoon will NOT go above 400ft. I downgraded the H, unfortunately I cannot figure out how to downgrade the st16 firmware. When the weather clears I will test again and see if the...