Recent content by PatternFlyer

Ok. I flew about 2 minutes not going far (under 50ft, gear down) going up and down. It was just before sunset and chilly with wind. So far, it didn't do the hiccup. I am going to try again when it's warmer.

I haven't tried flying it. I fly a lot of planes and a few other quads. If the motor stops in the middle of the throttle, it is usually the sync problem. Not sure if the ESCs on Typhoon H can be programmed or adjusted. Strange thing is the only 1 ESC is doing it. I can try putting the props...

link to the video showing the motor running.

No, I have to order the Typhoon H ESC Velometer Circuit Board from Yuneec

I tried connecting Left Center motor to the Rear Right ESC and connect the Rear Right motor to Left Center ESC. Left Center motor does the same thing. So, It should be the ESC board. Isn't it?

not sure how Yuneec number the motors, but I am having a problem with rear right motor. It starts fine, but during the acceleration, motor tries to spin the other direction, or stops spinning. Connected the motor to another airplane esc and complete tx/rx for testing. Motor runs smooth...