Recent content by Paullux

Again thanks for all the input. Yes I did put in the new one, the since the problem was identical before and after the change, It gaot me the inkling to follow all wires, separate overlaps, in checking the esc wiring I took the time to make sure each (orange, brown, red) wire was well set in...

Hi, in taking the top shell off and getting ready to video the occurrence, I started checking all the wiring. My replaced esc is hanging waiting to be put be in. By using the GUI I managed to get the motor to spin. So I have a faulty connection. What threw me off is the error was identical...

Sorry guys, thanks for all this, have been super busy and will be till Wednesday. I will review all the points, check wires, and post a video of the startup and what's hapening. Thanks again,

1-2-3-Same problem that led me to change both motor and esc. Both new, yuneec original parts. 4-Rear main led, 10 white, then red. Constant beep from craft 5-No didn't do that, will do a test. What Am I measuring, wattage? 6-Yes, made sure Again thks

Thank so much for your quick response. Yes I plugged it up and all looks good. Did the esc assignments.

Hi. The front left A rotor spins only briefly when start-up button is pressed, get 10 white flashes, then one red, and the unit beeps every second. I replaced rotor, esc, and did the firmware update, put on GUI and all seems fine. I get EMER on controller on upper left info panel of the ST10...