Recent content by Phil650

Small point but did you turn everything off first and then follow the video?

Thanks, but I've been tipping it until my arm got sore and it's still blinking blue. :) I had the same problem. Try the binding process here at 2:50. It worked for me.

Yes. However, after turning it off and on a few times it seems to be working now. FC, camera and gimbal updated successfully as well. Hopefully it will fly better than the previous version which was pretty bad.....

I decided to update to this version from 3.0 as I was still having landing problems and the flights were very twitchy. ST 16 updated ok (I followed the video exactly) but now the H won't go into bind mode. Any suggestions or is it bricked?

Thanks - our posts must have crossed!

So does anyone know what else could cause the landing problem? Everytime I have had problems, the altimeter has shown 0 ft when it's 20 ft up (everything has been calibrated several times, gps downloaded for 12.5 mins etc).

I have the same problem - the altimeter says 0 ft when it's still 20 ft in the air and it takes some time to land. I haven't tried the latest update yet as quite a few people seem to be having problems with it but I'm hoping it will fix this too.

I found that the update had been downloaded onto the sd card but it wouldn't complete the update process. If you turn everything off and on again and start the update process, because the file has already been downloaded the system doesn't start the OTA process but just looks for the file and...

Thanks, that's done the trick.

Tried the update this afternoon. The ST16 went ok but the H update failed. I used the OTA and the download worked, stage 1 of the update worked but stage 2 (the checking bit) failed due to 'Request time out' and error code 80002. Any suggestions before I phone Yuneec UK tomorrow?

Mine was working fine but I get the same message now as well

I've had the same problem with mine after about 20 flights. Hovering at about 20 ft, it was very reluctant to land, taking about 30 secs to come down from that height. The telementry showed it to be at -4.5 ft when it eventually came down. Yuneec UK replaced both the H and ST16 but the new one...

I just copied the file as it was downloaded from the Yuneec UK site onto the card and ran the update option. It extracts itself during the process.

Firerfox works ok and mine worked with the SD card supplied. I think you have to use one of 15Gb or less for some reason.

FAT32 is the right format.