Recent content by photomike72

Looks like its an EC2, these look like they will work https://www.amazon.com/Maxmoral-Balance-Charger-Connector-Silicone/dp/B07RNWKKXM/ref=sr_1_4?dchild=1&keywords=ec2+connector&qid=1628642040&s=toys-and-games&sr=1-4

Dusting off my old bird and the controller battery doesn't charge fast or good in the ST16. Heard that some folks have had issues charging it in the controller (mine does charge in the controller through the supplied usb cable but is sloooooooooow) and charged it externally with a charger. I''d...

will post back here if I have any issues in the next few flights

Talked to Yuneec CS and they walked me through a ST16 calibration and everything went well on my first flight tonight. They said no pilot error in my logs, but that I really only had partial control on my problem flights as my initial calibration wasn't there. Weird.

I'll do that when I get in from today's shoot. Will post back my results. Thank you for the info Steve.

they do not do this and calibration has not yielded success.

will do that tonight, thanks for the tip

That's where I'm getting these readings from. J1 100% up, J2 centered, J3 pegged 100 % down as well as J4 with no touching. Only stick that shows change when manipulated is J2, the 3 others show no change. Posted telemetry from the flights since update here and also in my other thread.

These are the last few ones since the update.

Sorry been a long few days.......

Dropbox - yuneec ST16 02017.JPG no flight log folder.... :/ ?

I'm getting inconsistent stick measurements using this method to check. J1 is pegged 100 percent up J2 is centered but any movements cause it to land a different spot each time it's released, J3 is pegged 100% down as is J4 without touching the stick. Wondering if this is big part of my current...

it never throttled down once it was on the ground but stayed at a level of power that kept rising 4-6 inches or so then down and then bounce. Did this 4-5 times with throttle firmly pressed in the full down position before tip over. I came straight down and in but stopped about 2-3 feet above...

Flew yesterday and almost lost it on landing, props wouldnt throttle back on touchdown. Skipped across the ground nose first held kill switch and it finally stopped and broke 1 prop in a tipover. New firmware for bird and ST 16, compass calibration and GPS warnings (tone and intermittent screen...