Recent content by Raptor1963

Mr. Garvin, where can the extended manual be found? Your feedback was great. I just got my aircraft back, when the weather permits I will test it out. Merry Christmas to everyone

I would all them. Ask for Brad, really sharp tech. They have a camera lab but they may want check more. They are good folks trying to help us so they would be happy to answer your questions to be clear. Good luck and keep us posted.

Since I go it back from the repairs, it would drift realy bad after a Gimbal calibration and then you use the pan option. Even flipping all switches forward would return it to center was another observation. They say it is fixed and it is on it's way home. I will hope for the best. Thank you...

Thank you Mr. Garvin. Very helpful information.

I have also watched every Yuneec and Youtube video, no restart is ever mentioned in any of the instructions. Thanks for the feed back, it helps.

Thanks. That is what I have been doing for every 5 to 6 CCC. I never had to restart. My H is in for GPS failure and crash repairs. All warrantied. It is back for a 3rd time at KAV for Gimbal issues after you Calibrate and try to fly, the second you use the pan, the gimbal just keeps spinning...

Biggest question is do you restart the Drone when the calibration is finished?

Also, do yo have to restart the Typhoon after the Gimbal Calibration?

Would someone be able to write out full instructions on every step ( not the manual, I have that) on all steps for calibrating the Gimbal start to finish?

My judgement so far says a passing vehicle on the ground did this.

I would listen for it, but what would happen was the second it touched the ground, even with left stick full back, the motors would start to die down but than speed up? I did the full calibration for the controls, it was fine until after I change the next battery. I was like revving itself, high...

Thank you everyone for the feedback. I am sure they will get it right soon enough. I am just frustrated because I would like buy a few more of the Hex's. My Quads are great for what I use the for. I am finding the Hex Copter can do it better! So I am looking to upgrade a few of them. It will...

Thank you. Not new to flying. Only new to this brand.

No, I did not kill it in the air. I let my H sit for 15 to 20 minutes, powered up to make sure the library data is up to par. I think that should be enough? I have many drones. I only use Angle. Probably over 20 hours a week for the last 2 years, Flying for almost 5 years. New to Yuneec though...

They confirmed it as said it was covered after I sent the logs in. It lost GPS and for maybe 30 seconds, no response from the controls as I tried to climb straight up. Meanwhile it was on slow drift where it finally caught a tree branch, which made drop. I did notice that all of sudden it was...