Recent content by Rhinosaurus

No, it went full white for failure. I couldn't even get the camera gimbal to calibrate.

Cannot get the compass to calibrate. Keep getting the "Compass Warning! Land in Angle Mode Immediately!" message. I am truly perplexed.

So i had a break in the weather and went out to the park to do a calibration on my compass and accelerometer. They keep failing and I and up with a solid white light. I came home and set it up on my kitchen table and tried to do just a camera gimbal calibration. My controller vibrated and told...

These guys have been great helping me troubleshoot whats going on with my H. I didn't think the buildings or the trees would cause that much interference. By the sounds of it those sensors may as well. I am going to recalibrate my compass and my accelerometer and try again. Combined with the...

You guys are all amazing! Its pouring down rain here for the first time in almost three months with lots of gusty wind, so an attempt at re-calibration and test flights are out for today. As soon as the weather cooperates I will do the compass and accelerometer calibration and give it a go. I...

The bouncing is exactly as you described it, and the controller completely ignored all input. Its as though you were there. I always fly in "turtle" because I am always near buildings but i will put my H into "rabbit" when landing from now on. The five rotor error has not repeated itself.

Has not happened again.

Thank you so much for your help. And it definitely started to have a mind of its own. I felt like i was trying to catch up to it. Thank you again, i really appreciate it.

I have done anything in channel calibrations or channel settings, wouldn't know where to begin. And my throttle slider is in "turtle". I have never moved it out of turtle because the flying I do requires me to be hovering around chimneys and rooflines and I would rather a turtle pace than a...

That chart makes sense for the actual incident, looks exactly like what happened now that its all mapped out. My ST16 is in mode 2 so that's all set, and when I look at the final outputs chart i can see only one channel moving at a time per joystick push. I get a slight wiggle from the readout...

Log number 39 was the one where it acted up on me. Log 40 was when I was at home troubleshooting. I looked over the flight logs but I am not knowledgeable enough with it to be able to decipher what I see.

I use my drone as a home inspector to view inaccessible roofs. I was about two inches from landing when my typhoon H stopped responding to controls. It banked hard forward and I was able to kill the rotors before it crashed into anything however the front two rotors ate a potted plant. I cannot...