Recent content by Snagglesworth

Looking through the sdk it should be possible. When a command is sent to the gimbal the result is sent back with the class gimbal.result public static void asyncSetPitchAndYawOfJni (float pitch, float yaw, Gimbal.ResultListener listener) set the camera pitch and yaw Parameters pitch pitch...

From my understanding rtk is used to cancel out GPS errors. You set up the Base station. The Base station is in a fixed position so it's GPS location never changes. With any GPS system you will get variations in the position being registered by it due to atmospheric conditions (GPS drift) but...

There's some information here about stripping down the e90. The filter is located in the lens assembly and not on the sensor so it may be possible to remove it but then you will have to refocus the lens which could be difficult...

I can't find the exponential functions anywhere. Has anyone found it?

For the back of the socket I used a pre wired plug off eBay. I think it was a 5 pin jst socket. As you look at the back the yellow goes to mTX/pwm then black to gnd and red to vbat.

Yes it will work. That's the same one as mine. If you look on page 1 post no17 there's a picture showing my wiring up off the back of the plug.

Yuneec and 3DR Announce Joint Venture 3DR Government Services | Yuneec Newsroom

800m range which will probably be more like 400m in reality. Nothing new here. It's a 2016 drone being released in 2018.

When I did the flight I remember thinking the same. I actually let it get to 4% before I gave up and put it in rtl. What really pisses me off is I tested it the weekend before the flight and it was fine, recording all images to the card. Take it out on an actual job and it fucks up. This is no...

I've just had the exact same thing. Did a mapping mission. 200+ photos gone and none of them saved on St16 (missions don't seem to save images to the controller, only manually taken photos). Also I had to change battery part way through and the mission would not resume, I only had the option to...

Not sure about the 520 cgoet, but it definitely works with the 480 cgoet. I can't see any reason for it not too work. The steadygrip is only supplying power and a single pwm signal for pitch.

Makes me wonder if they are trying to ******** me now. Mines in with them at the moment after a crash and they are saying pilot error, so refusing to cover it. They want £1000 for a new camera (only the gimbal sensor board has problems but they say they can't repair them!) and another £300 to...

Is it the gimbal or is it your sd card? It looks very similar to micro stutters you get when the sd card cannot write the data fast enough.

Try 123456789