Recent content by worelteam

Hello! I try to disconnect connectors and then i hear another error beeps. Compass is 3x beeps Gps is 1x pause 2x pause 3x beeps Can somebody disconnect motors, and check the error beeps?(only 3 of motors or 1pcs) not all4 .when all4 is disconnected you can't hear the beep sound I think is...

I dont know how can i measure the power. Motors is not rotating . That means that no power is on motor connector. I can only measure little power when motor beeps.

No motors rotating. But beep sound from all motors.if controller damaged no sound from motors

But my breeze don't make few spins. Is not rotating when i pilush the Take off button...

How can i post a video?

After power on only 4xbeep, with red lights.. than connected...

Thank you . Drone led blue, and green. App sensors all blue. And breeze not take off.

When i slide to take off, nothing happens. I dont know how turning manually. I have the breeze only 20 days ago...

This wire is cable to another type of lipo battery. I have removed them already. But the another battery work before without problem. Can i test the motor driver? The beep sound in breece is coming from motors. Is no beeper installed. I am thinking... When motor driver can send the beep...

All sensors blue, compass calibration sucessful. Slide to take off... Nothing happens...

Here is a dissassembled opposite side of the connector.... I try the firmware change . But no sucess...

The 4 terminals only use as balance charger. In the drone is only 2 pins used for 11v power supply.

No, all is blue

From battery is only 2 wires connected to circuit board.+ And- Motors are not dc with +and- polarity but connected with controller ac output for each motor...

I tried the solution with 20 rotations, but no sucess. During the crash was dissconnected the connector for compass.and connector for motor. It was both disconnected with power on. I have repaired the connection and compass calibration was succesful... I check all connections is now ok. I check...