Welcome to YuneecPilots.com!

Sign up and join the fastest growing Yuneec drone community.

GPS stays at acquiring & GUI won't connect

Discussion in 'Q500 4K Help' started by Funologic, Sep 15, 2016.

  1. Funologic

    Joined:
    Sep 14, 2016
    Messages:
    2
    Likes Received:
    0
    hello i flew my Q500 4K two times with no problem's but the third time i tried it. it won't connect to gps i've tried binding, calibration and accer but noting works. i've called yuneec and couldn't troubleshoot the problem so they asked if i can send it for repair. i"m going to send it but would like to if anyone has had this problem before? Thanks.
     
  2. Funologic

    Joined:
    Sep 14, 2016
    Messages:
    2
    Likes Received:
    0
  3. Toolman

    Joined:
    Sep 11, 2016
    Messages:
    17
    Likes Received:
    2
    My q500 can act funny like that. What I've noticed is it depends on where I try to take off from, as to how the gps acquisition works. To close to my house or car and it doesn't work....backyard doesn't work except for one small part. The most consistent place is at the edge of my driveway. Usually it take 1 minute sometime 2 or 3 minutes to connect.
    My advise is to try different locations and make sure there no power lines, metal or other things that seems to causes gps issues.