Welcome to YuneecPilots.com!

Sign up and join the fastest growing Yuneec drone community.

When is the transmitter fully booted up?

Discussion in 'Q500 4K Help' started by Timothy Smalley, Feb 24, 2016.

Tags:
  1. Timothy Smalley

    Joined:
    Feb 14, 2016
    Messages:
    9
    Likes Received:
    3
    Sorry for the dumb question but in a number of places in the instruction manual it says "Turn on the transmitter and allow it to boot up fully before turning on the aircraft." When is it fully booted up?
     
  2. Sirwilliam70

    Joined:
    Dec 31, 2015
    Messages:
    136
    Likes Received:
    53
    When it can see all the satellites in the area. The icon is in the top right corner.
     
    Timothy Smalley likes this.
  3. bshaker Air4c 1

    Joined:
    Dec 29, 2015
    Messages:
    129
    Likes Received:
    39
    I usually turn on the Q when the st10 starts to look for the connections (receiver & video). Also make sure that you have acquired enough satellites. (of course the Q won't fire until you're locked onto I believe at least 7 satellites).
     
    Timothy Smalley likes this.
  4. Timothy Smalley

    Joined:
    Feb 14, 2016
    Messages:
    9
    Likes Received:
    3
    Many thanks guys!
    Tim
     
  5. Buddy Collins

    Joined:
    Sep 29, 2015
    Messages:
    187
    Likes Received:
    17
    Location:
    San Antonio, Texas
    I turn the Controller on first and wait til I hear the Audio Signal (melody) that confirms it is booting up, then I turn on the Quad. Never had a problem with either, using this start-up proceedure.