Recent content by aerodron

I am aware of the differences in accuracy between RTK and GPS, but what do you mean by the statement “If RTK is connected correctly, it does not require an additional GPS”? What should a correct connection look like?

Hello. To answer WTFDproject’s questions in turn, yes, it is exactly the same H520E RTK drone model; the original was used and paired with a working drone. I’m not sure what you mean by “1.) It would be better if you made sure the base station is correctly configured and connected as a reference...

Hello. Sorry for the long delay in responding, but I had some personal issues. I’m attaching some photos. Basically, the issue is that when I turn on RTK, the GPS module disappears (it doesn’t work), and when I turn it off, it comes back immediately—of course, after restarting the drone. I also...

Hello. I’m having a problem with my H520E RTK drone. When I switch it to RTK mode, all GPS satellite signals disappear immediately. The drone’s battery is fully charged, I’m in an open area, and the device has the latest update installed. ‘polskipilot’ had the same problem at this link: H520E...

The thing is, some drones connect straight away (they connect to the camera immediately), whilst others take up to three minutes and still nothing. If I call it up about a minute after switching it on, there’s no problem – it connects straight away – but it should connect even after, say, two...

How can I permanently mount cameras on H520 or H520E drones so that I don’t have to search for cameras other than the E90 or E90Z?

Thank you very much for your help. I uninstalled Data Pilot, downloaded it again, and then updated it without any problems. I consider this matter closed :)

Hello. I’m having trouble updating my H520 drone. After successfully downloading the software, the drone refuses to install it. What should I do in this situation (I’ve attached some photos)? I should just add that I’ve tried changing the settings, but this message always appears.

Thank you very much, everything worked out – I consider the matter closed.

Thanks for the info; around 7.00 pm EU time (which I suppose is Swiss time :) ) I’ll get on with the replacement and let you know the results.

The colours of the wires on the camera are: red, green, black, brown, orange and yellow – I think those are the ones, as two of them are difficult to identify. Unfortunately, on the circuit board, the uninsulated wire doesn’t even have a small section left to help identify the colour. Below is a...

Hello. I have an E30Z camera for an H520 drone. As it has been dropped and some wires have come loose, could you please let me know which boards I need to solder the wires to (colours, diagram)? Could I also ask for instructions on how to replace the slip ring in this camera? I have attached...

Unfortunately, the battery was fully charged (I swapped it for another one and the problem persisted), so I decided to replace the entire circuit board, as the fault was clearly somewhere on it, but I don’t have the tools to check. Thank you for your help.

1. Just checking if the latest software is installed 2. Only one logo appears and the controller goes completely silent, as if a circuit inside it has overheated, because you can’t hear any fan noise. 3. It is currently 90% charged. How do I reset the controller to factory settings? What should...

The question is: has a component responsible for the entire system – let’s say, like a hard drive in a computer – been damaged? If so, where is it located?