Recent content by allu

The four screws were wrong position. That was the problem and after I moved the gimbal bottom mount and attached it to the pan motor right way it works like it should.

Do you know @WTFDproject or @h-elsner what is the reason when the camera pan control is in top position and when I put the pan control to top position the camera pan axel moves 180° when the camera is pointing ahead ? Same problem with second camera, the angle is 90° after selected pan control...

Ok, good to know in future. The camera works perfectly, but it still not display the versions of gimbal and autopilot. I did not do anything for camera because it is working well without counting the firmware version displaing. I am also interested if there is some hot shoe port on the cgo3+. I...

Tilt and spin are working and there is negative values between -10 to -45 in the fsk_rssi column. I measured the wires between camera and gimbal, those wires are working end to end. So, how can I do the downgrade procedure ? I tried your linked downgrade procedure, but it did not downgraded the...

I just tried to downgrade the Typhoon H with your procedures, but I did not get it updated. I copied the TyphoonH_Ver2.25_A.bin file to the sd card and then tried to downgrade it by using standard update procedure. First it is checking the firmware and then it informs that firmware update...

I will find out that can I install only the gimbal firmware version to the Typhoon H480. For example downgrading the gimbal version from 1.25 to 1.22 and then installing the v1.25 back. There is N/A on Gimbal version section. And where I can download old Typhoon H's firmwares ?

Ok, I read about your manual for setting up the flight modes and yes it looks like that I should only change some parameters in QGroundControl to enable mission mode. Or what will be the default modes enabled, is the mission mode included ? Thanks for your manual. I thought that if I make a...

Ok, I will test Thunderbird firmware if I get ST-link V2 dongle. Still a few questions about the firmware installation: - Are the compass, gyroscope, accelerometer and level horizon calibrations all the necessary calibrations or should I do some other calibrations ? - Should I set some channel...

Ok, can I manage camera settings (for example resolution, image adjustments etc.) by normally with ST16 ? And ST16's image and video buttons will work like with default Typhoon H ? I found this st-link v2 dongle: ST-LINK V2 Emulator and Debugger Dongle - PARTCO It looks like compatible and I...

Ok, thanks for your informations. Will the ST16 measure the voltage of the flight battery ? I found text "The ST16 is not monitoring the voltage. It waits on the Voltage Warning Flags that never come from Thunderbird." from Thunderbird manual. How the fully automated flights work, after...

I just found that Thunderbird firmware for Typhoon H480 and I am interested in using it for 3d mapping. I read from earlier messages that the Thunderbird firmware is ready for fully automated missions. So, can I use the Thunderbird for 3d-mapping by planning the mission on computer and then...

In the GUI the Z-axis made circle. I replaced the FC board and now it founds satellites and works well. So, the problem was faulty FC board. In case of NFZ tool I understand that you can not give it, because the business. I continue searching the tool from my archives ...

Thanks for your answer ! I downgraded the FC firmware from 1.35 to 1.28 and back to 1.35, but still same GPS acquiring problem. After that I downgraded FC firmware from 1.35 to 1.29, but same problem continues. After that back to 1.35, same problem. Does anybody know, what I can try next or...

Hello, anyone know how can I downgrade Yuneec Typhoon H firmware ? The problem is that the Typhoon H's GPS status does not show as OK when the Typhoon H starts. I have waited 15 minutes and still it informs me that GPS acquiring. It shows that 12-15 satellites have found, same on the controller...

I mean that I tried the Realsense without camera installed. So, I updated the Typhoon H with camera and its sd-card reader. My Typhoon H has now the latest firmware (V3.04): Autopilot: V1.35 Camera: V3.2.34 Gimbal: V1.25 RealSense: V1.10 And ST16 system version is st16_system_v03.01.b30 and...