Recent content by Anthony from France

I just looked in RC monitor, I actually have a problem in J4 which is very slow and does not exceed 50 or -50; no problem with J1, J2 and J3

I had tried after seeing the message to move them a little but without effect

Ok, thank you very much for this information, I will look at it tomorrow, because in France, it is evening... In fact, I must have had 2 problems, the magnetization problem of the compass (I will do a calibration anyway tomorrow to see if it gives me the message) but also and especially this...

I have (I had until yesterday, it could come back) also the messages in red in the history during the calibrations of the compass "Check for geom. interf."

I just looked, with each attempt to start the motors, I have the message in the history: "NOT ARMING: one or more RC sticks not centered"

I was not aware of this possibility of history; I will take a look at this and get back to you very soon. Thanks, that could actually be very useful.

Hello DoomMeister. I did not remove the GPS card from the cover and found that it was not upside down following the intervention. As I wrote on my previous comments, the calibration always flashes green at the end; only when I want to start the motors does it flash red. That's why I tell myself...

Hello everyone; I received my demagnetized compass today. Unfortunately my problem is not solved. I did a first calibration of the compass, I had again the message "check for geom. interf" and when I wanted to start the motors again the beeps and the red flash announcing a calibration problem...

Thanks DoomMeister for these clarifications, I found the right tools to remove the screws, but I have not started yet, I am waiting before the call of the person to whom I must send it to have the price, the deadline and address; he must have forgotten me today, I'll try to contact him again...

Possible...

Yes I know there are a few screws to remove, I think I found the right tool. The screws are very small. I thought I'd leave the card hanging. I'm waiting to drain the battery that I had charged for my tests in the last few days to drain a little, because I don't know how long I will have to...

Yes the compass calibration is done completely and seems to be done well. I even get the message telling me that the calibration is ok and all the lights flash green for a short time at the end. On the other hand, during the whole calibration, from start to finish, I got the message "check for...

The Aircraft is in Angle Mode （with GPS lock）(or sport) Calibration Failed Initiate Compass Calibration Accelerometer/ Gyro Calibration Completed; then The Aircraft is in Angle Mode （with GPS lock）(or sport) Thank you; I copied what it corresponded to according to the colors of the lights...

The heat from the heater was not directed at the drone at all, where the drone was the temperature was ambient, and the heater didn't work much this winter. Thank you for your answer.

Hello DoomMeister and 7Cyclops; following your advice, I tested leaving the drone on for 1h20 in an open area. It certainly helped, but I still have the same problem for the motors starting, beeps and lights flashing red. I also tried to start the motors by disabling the GPS and removing the...