Recent content by BallisticTyphoon

I experienced this issue and started a thread a while ago. Yuneec sent me a new unit and have had the same issues. The solution I have found is to raise it to 10' and then try again. It is very concerning when it happens honestly the other option I have found is to hand catch the bird and kill...

All of mine were on the SD card. They are in the form of quick reference cards and the Quick Start Guide. I did not get a full manual I am not sure if they offer what you speak of.

Rayray, The unit is brand new. This is my 4th flight. I had issues the second flight with a runaway that required a new landing gear do to a tough forced landing. RiverRunner. I did that after the repair and again now prior to the the flight just to make sure. I think I am going to check with...

No avoidance was off. I did cycle that switch while trying to land however.

While Flying today I came in to land and it would not come down. I was in angle mode, I was about 4" off the ground, I had the stick all the way down. It would not settle onto the ground. It was drifting and I had to keep bringing it back to the landing area. In the end I had to hit the STOP...

Ok so I did take off in smart mode. I did not pace it out but I believe I was 30'. Lesson learned... I would ask If it can cause this type of erratic behavior why would it be allowed? Also in this situation I swapped to angle mode and was still unable to control other than altitude. It also...

What is supposed to happen when you engage Auto Take Off? Up to 5M above ground and wait for input right? What about if you are in Smart Mode? Any difference? I had a different experience that included ducking. Please advise.