Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Chip

  1. C

    Q500 4k very unstable

    Ahh.. Ok.. so that is the same for all? mine was much more stable today than the past few days and to be honest when I got it first it was extremely steady but I can see from your vid it is doing very much like what mine is doing. I usually go flying with a friend that has a dji p3 and that...
  2. C

    Q500 4k very unstable

    I forgot to mention my st10+ is about 40' away and it is in angle mode
  3. C

    Q500 4k very unstable

    got it finally
  4. C

    Q500 4k very unstable

    Hi all. I posted a short video on youtube. I couldn't figure out how to put it on the site... It is a bit more stable than it was the movement is not as sudden. As you can see in the video it started just over the hedge that's behind it which is about 12 -13 ft high. Zero wind as you will see...
  5. C

    Q500 4k very unstable

    I will post one tomorrow.
  6. C

    Q500 4k very unstable

    Hi. Thanks to everyone for your advice. I took it all on board.. and in my tired state lastnight I got mixed up with the firmware version and the GUI version.. anyways I tried a few test flights today paying heed to your comments and it is flying a little more stable but not as stable as I...
  7. C

    Q500 4k very unstable

    Is that no reverse in smart mode only... or in angle mode also.. mine was no reverse in smart mode only.. right would go forward... left would go right and so on.. I will keep you posted on how my test flight goes in the morning after re updating..
  8. C

    Q500 4k very unstable

    Hi Agustine I just connected the drone to the GUI and it showed no faults but I did notice however that the firmware was at the v1.01 but I updated it to v1.07 the latest update when I got it.. I re did the update to v1.07 so I hope this will fix the issues.. I didn't get a chance to fly it as...
  9. C

    Q500 4k very unstable

    Yeah I agree.. do it right the first time.. thanks
  10. C

    Q500 4k very unstable

    Thanks for your suggestions. I will get in touch with them today.
  11. C

    Q500 4k very unstable

    Would that happen so suddenly? I will probably have to send it back to yuneec as I live in Ireland that means I will be without it most of the summer.. ****..
  12. C

    Q500 4k very unstable

    Could this problem be a firmware issue. Would it be worth while going back to the older update.. ?
  13. C

    Q500 4k very unstable

    Thanks for response.. tried that and all seems to be working fine.. They all return to 0. The ST10 is too new to be dirty anyway.. I never put it down on the ground and is stored in the foam cutout backpack after every session
  14. C

    Q500 4k very unstable

    Hi all. Fairly new to flying drones but learning fast.. my q500 4k over the past few days has gone a bit crazy.. I have very little control of it in smart mode.. no backwards movement at all and not going where it should be according to where I push the control stick to.. angle mode hovering is...