Recent content by Cobra1974

Well done to WTFDproject and to all of you, because this type of drone is now 7 years old, and it lives on thanks to you, the enthusiasts, who keep it going. Yes, there are brands like Dji, but can they change their camera and install a thermal camera like the CGOEt? No, they can't. They have to...

SUCCESS!!! Between two rains and with 14 sat. I flew it for the first time! And it works. Well, I didn't understand why I didn't get any video feedback in the field when I tested it at home. But I'd like to thank you very much for your help and support, and if I can help too, please don't...

Weather permitting (it's raining at the moment), I'll give you a report on my first flight. Thanks again

You're the best! I searched the Forum and found a link to you and it works. Thank you very much if I can help you? I know that this drone no longer exists and I have a remote control for piece in case you need or for a translation into French of something.

I've got good news and bad news! The good news is that the remote control responds and works again. The bad news is that I can't see the CGo3+ camera or the drone. Do you have any ideas? I turned on the drone after the remote control, switched on the wifi and the home network access and then...

The problem is that we no longer have support from Yuneec and when I search for files I often get "File not found" in the Forum or old links. My only hope is that someone has the files on their PC and shares them, or that someone else has had the same problem and tells me what to do! Otherwise...

I haven't found it I would suggest this site to find it

YUNH105 - 14,8 volt is the Typhoon H

And on this site Yuneec Skins

Is it possible to empty the ST 16's memory and then re-install the FACTORY configuration without any remaining memory, i.e. start from scratch? Or is it possible to flash the BIOS?

Yes is exactly the same

Thank you so much

Do any of the control devices show any response on the test (Hardware Monitor) page? Response NO but you;ve a other firmware ( specific for ST16 ) ?

Thank you so much. I was wondering, isn't it the US firmware? Isn't there an EU firmware? Or more recent?

Nothing :-(