Recent content by Dave I

due to health concerns my H+ hasnt flown since 2021, is there a simple way to update the controller and the bird, dont wanna take any chances and think I should update before I calibrate

where in the world are you ?

Enjoy the day !

Took the test flight and all went well, final output all matched close with the previous, except I forgot CH 8 was camera pan and not rate slider, after a few anxious moments it all came back, 15 satelites on both and good power, performed all movements in both modes and landed successfully...

Gusty winds this morning will try later, heres my updated flight list, will fill in as test goes on, trid final output now, results same

Thanks for the great help, hopefully all this will prevent someone else from having the same problem, Now that I am confident RTH will get me down successfully I am going to make a checklist and run the field test again to assure that I do it all correctly and you have something to check...

After, I think as long as I have the ST on the bench I'll probably re install realsense module just to make the flashing led easier to read, had no luck finding just the cover --- I will attempt downloading GUI. this evening

Here are the results, let me know if they are not legibl, and no I do not have a GUI file

Thanks Again, one thing at a time, did you mean J1-Throttle or J3 forward back ? not that it matters, Im confused, the initial stick tests in rabbit and turtle mode all acted normal, the J1 rose and descended as normal in both modes but telemetry showed otherwise ? When I split the st I...

Heres the newest flightlog after todays test flight, all went well in rabbit mode,switched to turtle mode and moved sticks J1, J3, J4, and J2. All functioned as they should. Switched back to rabbit and began descension to land, dropped to appox 12-15 feet of altitude and stopped, now it...

I see exactly what you mean now, the pictures make it perfectly clear, I will go back to step one and calibrate all again, and then go outside and do the compass and then send you the flightlogs, rabbit mode up, down, forward, back, left, right, spin left spin right --- repeat in turtle...

Just checked the final output display, channel 7 camera tilt registered the same on both ends and I was able with finessing to get it to center at 0 % should any other channels be significant, channel i was 70% up and 10 % down, I should try to get the turtle hare in approx the same...

I am a little confused, I just did the controller calibration, both sticks and both sliders are all at approximately 2048 centered and passed, but you say ignore the numbers, how do I physically center them, just by eye, or should I go back and do it again with being centered and passing the...

Steady rain today so I may not get to test flight, will do the controller calibration in the shop, I have did it before to fix J3 not centering and now it is important to make sure the rabbit mode is centered and camera pan slider, not just the beep but the numeric values before exitting...

Thanks and have a great weekend, gonna attach the camera and try another test flight in rabbit mode Realsense module on the workbench, has a bit of black goo on the connection. Will advise later, Thank You