Recent content by Dezt1980

That’s the plan B, I’ve seen a few from Germany for just over £100, just need to sneak it past the wife.

Great, I think a full tear down is going to be in order now to check other areas.

Thanks for all the help and suggestions on this. I’ve contacted Yuneec UK and they’ve got back to me to tell me that they can’t swap boards as they’re programmed to the camera and gimbal. It’s time to break out the soldering iron I think. @WTFDproject how did you get everything working using...

Thanks h-elsner, I’ll give that a shot and see what happens. Got my fingers crossed that’s all it is that needs doing.

This is the damaged area, I wish it was easier to see what was causing the issue.

It sounds like 3 short beeps, I’ll try Yuneec uk and see what they say, otherwise it’s hand in pocket for the cgo3 and cable.

It is D that has come off, the control one. I tried plugging straight into E or F and it did the same thing. It beeps and flashes red which I’m not sure what that means.

Hi all, I’m Derek from Blackburn in the UK. I currently have a q500+ with a cgo2 which has taken a bit of damage. I’m hoping to get a bit of time to fly a bit more when the kids get older and I get a bit more free time.

Hi everyone, I wonder if anyone can help me after my unfortunate crash that has damaged the cgo2 power board. Unfortunately the plug that goes to the top board from the bird has come away. Is there anywhere in the UK that might be able to help get this sorted? I can’t find any replacement...