Recent content by ezed1

So is it clear to say that you could NOT swap camera innards from one housing CG03 to another CG03+ and vise versa

Thanks for your input but the culprit is the cameras WIFI card I swapped it out with one from another camera I purchased and the signal and range was back to normal first i tried the purchased camera and it worked fine so then it was either the gimbal board or the wifi card the gimbal board had...

glad you mention that because i have already been poking around inside the camera and thought the gray part on the ribbon cable connector was a latch ;-/ needless to say it broke apart like paper :-( after some time i was able to get the cable plug back in held down by some 3m tape SMH as for...

well its definitely in the camera somewhere because it acts the same way when its mounted to the steady grip connected to my tablet, up close signal is fine, move a foot or two away and signal is lost :-( got my eyes on a camera now i will update my findings and thanks for your input

Is there any body out there who has kept any or all of their firmware updates to date willing to share, I really like the camera drone but these out of the blue problems got me thinking and the sorry yuneec support seems to be no where to be found but when they they do poke their heads up its...

Gimbal and camera not working on bird or steady grip ,on bird gimbal light just flashes camera has no light, on steady grip gimbal attempts to work but just vibrates camera has no light at all, after creating a new model and doing a rebind st10+ only sees the bird ,no camera can the gimbal board...

Thanks

What is the purpose for the red rear motor lights and the white front motor lights??? what are their suppose to be signaling or telling you ?? I have a red light out but the motor runs fine and its not the LED because i move it to the other side and it worked fine :-(