Recent content by FLDirector19

https://www.ebay.com/itm/186374960486?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=5Hh8DH_QTMS&sssrc=4429486&ssuid=5Hh8DH_QTMS&var=&widget_ver=artemis&media=COPY PRICE REDUCED… If you are looking for the largest off-the-shelf drone that Yuneec produces, you’ll be looking at the Yuneec Tornado...

Greetings!! It is now a couple of years past the timeframe listed above. If the NFZ for H920+ now available?

Will this work for the H920+ as well?

Good evening!! I was looking over some old posts and noticed you fly an H920+. If you could offer me some assistance, I have a thread in the 920+ Discussions, as “Newbie needs help”. Any guidance you can offer, will be greatly appreciated. Best regards, Tom Mitchell, Sr.

YuneecSkins has a photo of the schematic you seek on their website.

I agree… I read the same thing. Problem is, apparently the H920+ does have NFZ software.

Does anyone have a current/update solution for the NFZ release issue on the H920+? When I attempt to initiate the H920+ after the controller, the H920+ all I get is the red-red-red-red-red-red-white status light... which obviously prevents the rotors from spinning.

Thanks to everyone that supplied ideas, thoughts and suggestions. I was reviewing old posts this morning and realized I left this activity hanging. I actually returned it to the supplier, finding out he is a member of this forum and has been watching the exchange of posts. Purchased a *new*...

Not sure if you’ve checked, but from the included photo, battery (2) doesn’t appear to be squarely seated. I know from experience that having one battery not completely installed will cause less flight time.

Will you be receiving an batteries for the Tornado H920?

Ok… here is the latest update, with photos. I checked the voltage on the H920+ batteries & charged them to 23v, while I charged the ST24 to 90%. Checked the SR24 to see if the yellow light flashed faster after the tipping… it did. I put the aircraft back together, reattached the CGO4, then...

Thanks! For some reason, this showed up on my current feed.

This is dated 2017. Is that correct?

Does that make the SR24 bad, or something else?

I can try that, however, after I select the new craft, it doesn’t display under the camera line. Also, I don’t have the SR24xxx on the opposite side.