Recent content by FlyBry

I didn't see the output available to control the gps with hardware

Dave, Easy enough to set up in advanced mode. Cut the gains for max output, or map the aux switch to j2 to cut the gains when needed.

And yet still, no one can tell me what channel 12 controls:mad: Sure hope its a dry set of contacts so I can map the AUX button to it and hook up an Aux load to it.

Want faster yawing? go into advanced mode and then click on the J2 button and increase the max out to 125%. You can also do this with the other motions and pick up extra HP.

Another hidden feature, Tap the crap out of the about controller button on the lower left hand side and you can access the controllers hardware calibration screens as well as other telemetry options.

Here's another one, If your using the android pad, surfacing the web, playing with an app etc, you can hold down the red start button and it will put the controller in hibernate. To bring it out of hibernation, hold the red start button down again. The nice thing about this is you don't have to...

I'll give you another hidden feature. If you go to about controller, and tap the crap out of the Yuneec name on the lower right hand side of the screen, a WiFi menu will come up.

I'll explain but not in this thread. I'll start a new thread that will be easier to search and let you know. For now, I'm trying to find out what output channel 12 does. Surely someone knows what the heck it controls, sure hope it is a spare form c relay.

Go to settings. Enable advanced mode. Return to the main screen. Tap: channel settings. Hold down the start/stop button. Pay attention to what the indicator scale at the bottom reads and reply back to this post. Based on your response, I may be able tonhelp you out.

Folks, If you have been using your H for a while, you may have noticed that the battery doesnt always seem to seat fully at times, what the heck? Well you may need to do a bit of surgery. Eventually over time, the front sonar board foam insulation that seats around the outside of the board and...

Folks, After many many many destructive experiments with the H, I highly recommend everyone put a bit of glue around and in each of the prop arm pop-rivets. There are 2 located on each arm, and eventually the center wedge piece may/will vibrate loose and then your in trouble. They will surely...

Folks, I've mentioned in the past that I get just as much enjoyment from flying the H as I do tinkering and repairing it. That said, my style of flying is purposely a bit loose, I usually manage to wreck the H about once a month, not that I intentionally seek to do this but and that if I wanted...

Programming the ST16 channel profiles and mapping inputs to outputs in advanced mode is intuitively easy, I made a Fast Mod Profile that makes the H perform much faster than the standard profile. I turn, elevate and accelerate much quicker than the default setup, not recommended for photo...

I can program in advanced mode just fine however, I am curious about channel 12? I programmed the auxiliary button to it and am wondering what channel 12 does? Perhaps there is a dry contact on the H board that is mapped to channel 12?

I had a similar problem after I reinstalled my landing arms, but was able to correct it easily. What caused the problem is that I taped the antenna wires solidly at the spot right before they go into the antenna tubes. I simply removed the tape allowing the antenna wires to freely slide in the...