Recent content by Flying Bird

Thanks Steve! As suggested by you, I have captured all the pictures and made small videos showing the status of the Drone. I am taking it to the flying field tomorrow for the flight test.

This message is especially for Steve. Steve your prompt suggestions guided me in the right directions!!! I took decision to fix my drone on my own rather than Yuneec Repair Center (charging me $362 including shipping) fixing it for me. I called the repair center to return my drone with out any...

I agree with you Steve on: "However, there aren't many bits that will fit into those deep pockets so a driver is still the best method." Also, DrNewcenstein is right about tiring job of 63 screws! I have received my Drone from the repair center. The cost was way above my budget, therefore, I...

That's a good suggestion. Thanks for sharing it with me!!! I will take care of that and will not install my camera until everything is as you said "airworthy"

I will take all the pictures and post them here as well.

Yes, It is more work for me but I would happy to see my bird flying! I have all the tools that you just mentioned in your post (i.e. Long shaft hex drivers). I hope this will work out for me! Thanks for all the help.

Sure, I will open the drone and check all the connections. I will definitely keep you in the loop. Thank you for all the support and sparing time for all this!

Yes, I pulled it many times as I was thinking that this is the only way to connect/Interface with GUI. I used tweezers to pull it out and it was very hard to come out from its compartment. Later, I found out that there was no need of doing all that effort. I am thinking to open the drone and...

Yes you are very much right. There is only one connector. Initially I did not notice it and I was trying the old method of using tweezers and pulling out the connector from the right side of the drone but later I found out that there was no need of doing all this. May be this has done something...

This one is with Charcoal color scheme.

I have tried every single combination but every time ESC failed. No response or aural tones from motor 2, 3 and 4 plus GUI is not indicating any shift. The drone main LED is always blinking in RED. As per Yuneec Instruction Manual on page 34 it is stated that "Typhoon Pulses RED and won't...

Yes, the drone always faced as it's shown in GUI. When I click on ESC ID assignment tab it indicates to rotate motor one in clock wise direction, however, doing this never produce any confirmation tone nor it shifts to motor two and onwards. With in 3 to 5 seconds system pops up the message "...

I kept my drone at one position all the time on leveled surface. I did not notice whether my orientation was correct or not. Is this is something that's stopping my motors to start?

For performing compass calibration?

I bought this unit in the month of July 2016. Now the warranty period is expired and the repair center estimates are too high ($ 331 labor plus 4 motors).