Recent content by Gerfnad

I agree, went out to do a test this morning. Used a battery that was at 15.5v (removed when warned last flight). It didn't send a warning at all. Flew until 14.6V no warning, only a few minutes. I didn't fly it to alarm because it started raining again (rain and cold, not the best for...

It's with all 6 batteries. I do have a batter voltage tester and it reads 15.5v every time. In the telemetry report the battery voltage drops slowly, as it should, no spikes or dips. The warning actually says 15.5v if I remember correctly. It's raining today, but if it clears long enough I'm...

Thanks for the info. I swear the warning said 15.5v but who knows. I'll take it out tomorrow and fly it until I get a warning and double check the voltage.

This is a used system I purchased. Updated all firmware and everything looks good, normal flight mostly just hover and taking pano's. But the battery warning shows up very fast, less than 10 minutes at 15.5v.

What would I look for in the telemetry file?

My H starts complaining and throwing low battery warnings at 15.5v. This seems awful high, is there a way to adjust the alert level as in DJI craft?

Yeah, I was looking for this as well. It is not in the manual - typical. Yuneec has HORRIBLE documentation.

Yeah, this forum is worthless. Ask a question and all you get is some ******* telling you to have a backup drone. ********.

Update to my Update... While I was able to see drone voltage and OBS did not immediately fail, still no good. This thing is bound wrong or something. Will only power up rotors if power up controller AND wand, press engine start on both devices at the same time. Then both fight over who...

Ok, here's an update. I think there was a binding problem of sorts. While on hold for tech support (1+ hours), I was fooling around with everything. With the ST16 controller turned on I turned on the wizard and tried to connect. The ST16 then connected and showed bird voltage and OBS was...

I also have 2 DJI's and was able to use those. But the Yuneec is far superior and my main goto drone. But it does look bad when your goto bird simply will not connect in front of the customer.

I've had the Typhoon for about 2 months now, everything has been working GREAT. BUT, yesterday I flew it for the first time with the wand. Worked good. Put away, had a job today so took the drone out and COULD NOT FLY! Got constant OBS Failure and no Drone Voltage showing on the controller...