h-elsner's latest activity
-
I'm trying to use the CGO3+ with a H920. Tilt was not possible with the PWM signal from H920 flight controller. CGO3+ is only working... -
-
h-elsner reacted to WTFDproject's post in the thread Help: Chroma Blade Drone With Yuneec CG03 Gimble/Camera with
Like.
I could not find an actual pin out for BLH8605. This is how I read it. Use at your own risk. Maybe someone else will comment. -
h-elsner replied to the thread Help: Chroma Blade Drone With Yuneec CG03 Gimble/Camera.I believe he refers to the Update Board: Chroma, BLH8605. There is little support. by quick search I found one in Switzerland...
-
h-elsner replied to the thread Need help with H520e and controller.Yuneec made several changes in PX4 Autopilot for their drones (i.e. H Plus, H520, H520E). Do never use PX4 firmware from main branch. It...
-
h-elsner reacted to WTFDproject's post in the thread Problem with US software on Leica camera and H3 drone with Like.
In general, it's called a "pitch spring". It is caused by any single or combination of several alignment issues related to the...
-
h-elsner replied to the thread Blade Chroma, need Manuals, Binding.I would create a new model before setup and bind both, camera and drone. It's a better start point if we do not know what happened...
-
h-elsner replied to the thread Flying Typhoon H Plus after several years.It is not difficult, not dangerous and does not hurt to look at the flight logs after the flight. But you can see quite well how the...
-
Some pictures of e90x wire
-
h-elsner replied to the thread Typhoon H 480 PX4 v1.10 (Stability issues ;-).Those pins belongs to ESC control.
-
h-elsner replied to the thread Typhoon H 480 PX4 v1.10 (Stability issues ;-).Is this an optical flow sensor? On which port did you connect it? Do you know where Serial 1 is assigned to HW port? Serial1 (tty1?) not...
-
h-elsner reacted to korakora's post in the thread Typhoon H 480 PX4 v1.10 (Stability issues ;-) with Like.
Sorry For ThunderBIRD only *because lack of SERIAL port, i must use ESP32 to make some extended port (FYI: Serial1 in thunderbird...
-
h-elsner replied to the thread GPS not working.Another message is SYS_STATUS. Here we should see what HW sensors are present and working (and if there is a second GPS/compass)...
-
-
h-elsner replied to the thread GPS not working.I have no experience with H520E but the principles are always the same for PX4 based drones. The compass and the GPS are on the same...
-
-
h-elsner replied to the thread Help: Chroma Blade Drone With Yuneec CG03 Gimble/Camera.You can try to calibrate it with the CGO3oldCali tool. I have successfully calibrated a GB203 gimbal which has the same control board...
