Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by ICEx89

  1. I

    Gimbal gone crazy

    I didn't,i couldn't find any confirmation on the fuse size(amps) so i ended up soldering one of these Amazon.com: AutoEC 20A Inline ATC ATO Waterproof Fuse Holder (1 Set): Automotive to the board and putting in a 5 amp fuse in it.
  2. I

    Gimbal gone crazy

    it is. so you need to desolder it to remove it which is a pain in the *** since it is an tiny smd
  3. I

    Gimbal gone crazy

    no, i purchased a new one, il probably send the old one inn for repair if i find someone who can encode/reprogram the gimbal in my country. did you replace the motor yourself? as far as i know if you replace any of the gimbal motors og the circuit boards it needs to be reprogrammed/encoded to...
  4. I

    Gimbal gone crazy

    i did try running calibration but the camera/gimbal don't move during the calibration if a shaft was bent i would expect that motor to have trouble moving or make some scraping noises does the camera/gimbal have it's own gyro or does it use the drones gyro
  5. I

    Gimbal gone crazy

    hi i recently crashed my typhoon h. landed on the camera, bent the gimbal arm, cut the slip ring wires and shorted the little white fuse(marked with a K) on the power distribution board inside the drone. i have replaced the slip ring and gimbal arm and replaced the fuse with a 5amp one(kinda...