Recent content by jgann055

I think I found the problem. I have a fixed length lens on there :/ All problems solved thanks to you guys. Very much appreciated!

You got it seabee! Once I switched over to Program AE Mode, I was able to take video! Still no zoom, but that is less critical. Thank you!

Well, I tried every combination of settings, and I still get the red error message at the top of the screen every time I press the video button. Also the zoom slider will not leave the center. I pull up to increase zoom, it goes back to center. Same when I slide it down. Any ideas for a next step?

I bought a used H920+ and cannot get video to record from the CGO4. I have control of the yaw and tilt, can take pictures, but cannot zoom or record video. When I press the video button I get a red warning at the top of the screen "Please do not operation in this mode". I tried resetting the...

Thank you Seabee. I got mine used, and the previous owner didn't have them installed.

My H920+ did not have the quick release hardware installed. I bought some and am having difficulty installing the pieces to the motors and props. I think some photos might help.

Can anyone take a pic of both sides of the quick release propeller for the Tornado H920+ ? They should be easy to install, but for some reason I am having difficulty. TIA

Thank you for your quick response! I will take your advice and do what I can. Thanks again for helping me through this. Very much appreciated

Results! Power 4 battery 1) 2.1 2)1.1 3) 2.2 4) 2.4 Total - 6.3 V Powerextra batttery 1)1.3 2)1.3 3)1.1 4) No value Total - 3.6 V I am assuming the dead cell in the Powerextra battery is the reason for that error. Is this of value to anyone, or just recycle it? Any idea with the Power4?

Thank you!

I will have to ask around. Would be nice to know a bit more about what is going on with these batteries.

I do not. I may pick one up.

Yeah, I have that connector. When I plug into my charger, no values appear for any of the cells. Absolutely nothing shows up. I plug in a good battery, and each cell voltage appears. So I know the connector works. Shame about the batteries because they both are not puffy.

I don't know how to do that. I always just used the LiPo charger to give me cell voltages. What would you use to check?

I purchased a used Typhoon H with 2 batteries. One is the Power 4 and the other is Powerextra TYP-H001. Both batteries give me the blue error LED when hooked up to the OEM charger. When I hook them up to my LiPo charger, the cells values don't register for balancing, so cannot charge. I tried...