Recent content by Jgrego

Okay, just disregard this post then. I found that while the DataPilot and Update Pilot versions were correct, for some reason the Remote Control version was out of date. I factory reset the ST16s and after starting from that, once the updater got everything to the current version it had no...

So our setup for our H520 has always been one ST16S for flying and a second ST16S as a slave remote to transmit the video feed to a monitor. Our original remote recently bricked itself during a firmware update, so I'm trying to use the second remote as a primary now. I took the remote out of...

Well we got to the bottom of it... Our 2nd remote only came with Flight Mode 2.0 installed. And our primary remote only had Data Pilot installed. Once we got data pilot up and running on the 2nd remote and put it into slave mode everything transmitted just fine. One other interesting thing...

Thanks arruntus, I'll try looking for that option next. And Steve, we haven't tried that yet, but that was our next option. And everything is running the most current firmware. I've got a support note into Yuneec, but I'm not holding my breath. Thanks for the tips again.

We aren't using the 2nd remote in team mode (where remote 1 controls aircraft and remote 2 controls all camera function). Our remote 2 is only there to mirror the screen of the pilot. It has no control of the camera. The pilot's remote still maintains all flight and camera functions. We have...

We have an H520 with the E10T and two remotes. Our main remote works fine, showing both the thermal view and the optical view. Our 2nd remote is paired only to the camera to function as a separate viewer. The 2nd remote shows the optical view just fine, but doesn't show the thermal. We tried...