Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by jmason121

  1. J

    Gimbal will stabilize then un-stabilized

    So I just check the pitch magnet. Photos are attached. There was definitely some stuff to clear but now I am getting a 3-beep code when I turn my drone on. Do you know what this means? Here is a link to the video of what the drone is doing now.
  2. J

    Gimbal will stabilize then un-stabilized

    just checked that. it was reading
  3. J

    Gimbal will stabilize then un-stabilized

    Where do you check for that command?
  4. J

    Gimbal will stabilize then un-stabilized

    Thank you so much for the document! I am going to attempt that tomorrow. I appreciate the feedback.
  5. J

    Gimbal will stabilize then un-stabilized

    Sounds. Good. Thanks, Vaklin! Unfortunately, this last time I turned it on and the gimbal started to shake a little more than usual. I am just going to keep it off for a little and probably wait till tomorrow.
  6. J

    Gimbal will stabilize then un-stabilized

    Here is a photo. This is with the ST16 powered off. The camera is just facing down and when I try to move it up (gently) with my hand it will not let me.
  7. J

    Gimbal will stabilize then un-stabilized

    I did and I am noticing that the gimbal will stay stabilized but the camera is in the facedown position. Also, when I would turn on the ST16 this last go around (10 minutes ago) The gimbal had stayed stabilized the longest it has (around 2 minutes) but the tilt would still not allow me to move...
  8. J

    Gimbal will stabilize then un-stabilized

    Hey sorry about that. I uploaded the video to youtube and linked it in the post so you should be able to watch it from there. Let me know if you are still unable to watch. Thank you.
  9. J

    Gimbal will stabilize then un-stabilized

    Hello, attached is a video of the issue I am currently dealing with. I will turn on my drone and then my controller and the gimbal will keep going back to being stabilized and not being stabilized. I still have control of panning when it is stabilized but cannot tilt the camera up, it stays in...