Recent content by Loris

ok thanks i understand nice to hear from you Helmut, I translated your q500log manual into Italian, post it if any friend is interested

thanks thanks thanks but while you were writing I had already opened the ST16 for an inspection and I had removed the WIFI module just for a visual check, then I reassembled everything without seeing anything the connectors were all in place but perhaps someone had made a little oxide and when...

certainly i am interested, anything i can try i will. and all your suggestions are welcome

Update I managed, by entering the secret menu, in the WIFI test section, to access the PAD menu by pulling down at the top right and I was able to force the WIFI by activating it manually but then returning to the camera selection it tells me that the WIFI is not detected. I believe the ST16's...

DoomMeister, HI sorry but maybe you didn't read my previous post, it won't let me do anything, i can't go to the pad menu and i can't pull down the top right drop down menu, if i'm lucky, on power up, but i don't always get it, by holding down the top right i can see for a second the menu which...

I think the problem is with the ST16 because I can't skip the error message and enter the other menus. For example, I also have the UAV pilot key simulator and normally with the typhoon off, I only turn on the ST16 and go to the model selection menu and choose simulator. Now I can't do it...

yes, but from information menu I see also "WI-FI NOT CONNECTED"

I found this post and although dated I would like to reconnect to the discussion. The last time I used the typhoon, I left the st16 under the sun for a few minutes and saw the display with a dark spot, I gave it little importance because this is quite typical of liquid crystal displays. Now...

thank You again

Hi H-Elsner Thank you very much for the tips and help you have given me. Another question the 4 leads that need to have enough tin above are connected together and so I guess if the 2 that are very close also short due to tin nothing should happen right? Grazie molto per le dritte e l'aiuto che...

Okay I didn't get it right, you know language is always a problem and I never want to be rude or disrespectful to anyone Ok non avevo capito bene, sai la lingua è sempre un problema e non vorrei mai essere scortese o irrespettoso verso qualcuno

Sorry but i don't kwon to have understood You, I'm italian and off course i use an automatic language traslation because my english it' not very good. but what I have to do? I have to syay out from forum? I believed that the forum was open by everybody. This time I didn't use an automatic traslation

No, sorry maybe I explained myself badly, my motherboard is the one with the clean solder, but I had a problem with the left motor and it was due to its ESC then investigating better I discovered that its fuse was blown. in the meantime I had already bought another mother board on ebay and it's...

However, the problem remains of where to find and buy these smd fuses. In another post here on the forum I read that they are 20A it seems to me a lot, however if this were the case they could be replaced with easily available alternative fuses, there are also very small polymer fuses.

Yes I have two motherboards, because I hadn't tested the fuses before and I bought another one on ebay. Now that I have discovered the problem on my motherboard I would like to fix it by replacing the blown fuse and keep it as a spare since I have now bought another one, my fault