Recent content by maknak

Hey - made cleaning as you advised. found few black bits. Don't know if that could cause some interference but i did this: 1. Cleaned shaft as you advised. 2. Resolded connections ABC - i reduced amount of solder that i have used previously and this time i was using Flux. AND IT IS FLYING AGIAN...

I hope all advice's will play good and i will have a chance to record more. I am saying exactly the same thing to people in my town - they are living here for 50-80 years and none of them saw towns castle from the the sky. Once i am publishing some local video - its always have positive...

Hi There, The problem is with the "A" Motor. I do not use my drone often and since i bought it i have noticed that twisting is a very poor solution and dont know who had this idea to put this in place (this is my occupation background). After about 30 flights the thread was sized. (see photos)...

@WTFDproject 1. Yes my GUI went fine i have all for motors tested and calibrated acc. All in green as per Q500 screen attached. 2. I reconnected everything when it comes to cables (plugs and soldering) at ESC board which is at the motor. @jannislh How i can mount propellers in different way...

Hi There, One day the thread at motor A was damaged (i used drone maybe 25-30 times), drone was still inside warranty (10th month). Called laptopdirect.co.uk to report warranty, they have send me to Yuneec UK, i send same emal to Yuneec UK where i was informed that my drone is outside warranty...