Recent content by Mariooct

Do you by any chance have a schematic diagram of this control board a friend of mine and I want to look into maybe replacing damage parts on the esc's and board instead of going the expensive way and replacing the whole thing.

Hi, h-elsner I have been busy with work thus the reason I'm only replying now what I have do so far is I've bought another 350qx 2 updated to version 3. So all 4 esc's is bad I took the good ones and put it in the damaged QX done the esc assignment and it initializes but still get the low...

I've tried the bridge but it still works on,off from the switch and not direct power from the battery.

So the bridge you marked must I solder a peice of wire from one side to the other?

Thank you so much for your replies i will check this out and give feedback of what I find.

My main board looks different to the one in your picture I have the version 2

The cell voltages is all the same I have 2 batteries doing the exact same thing when fully charged in balance mode checked ec3 connectors no damage but resoldered it anyways and at board connection as well. I'm beginning to think i might have a faulty board.

I have checked the battery voltage with a multimeter voltage is correct and also all three cells voltage is perfect but I still get the warning lights and Gui low battery voltage.

Hi I have a problem with my blade 350 qx2 its constantly in low voltage mode with red,green,blue and white light flashing when I plug it into the GUI it show low voltage with a full battery.