Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Max1138

  1. M

    400 foot ceiling

    The story so far for those following along.... The 400 limit appears to definitely be located n the Autopilot firmware. I believe v1.30 has the limit, v1.35 does not. I also found that once the license is entered into the GUI, the NFZ disable/enable appears in the menu. This is an odd one...
  2. M

    400 foot ceiling

    Do you know which version of Autopilot FW you are using?
  3. M

    400 foot ceiling

    Correct. Based on the operation of the GUI, it would not set parameters for the ST16. If it did, we wouldn't have the 400 foot limit if set higher in the GUI. However, based on your experience with v1.35, I am going to try an experiment similar to your setup. When I originally tried v1.35, it...
  4. M

    400 foot ceiling

    Interesting. Does the 400 foot limit exist in the European software? It sort of makes sense that NFZ would not effect the 400 limit, but it is unusual that the GUI which was specifically designed to make the change has no effect. I wonder if the limit is built into the ST16 and not the Typhoon...
  5. M

    400 foot ceiling

    The NFZ code when installed definitely removes the NFZ limitation but from my experience, not the 400 foot ceiling. I suspect that the ceiling limitation is controlled in another area of firmware not effected by NFZ. Because of that, it may take a firmware mod similar to NFZ to remove it. What...
  6. M

    400 foot ceiling

    Hello all I am seeking assistance and I dont want to hijack a thread. I have used the search function and see several discussions but no solution has worked. I am looking into whether this is a me issue or if others are having the same problem. I have a Typhoon H that I recently did the NFZ...
  7. M

    3D Print model Typhoon H

    Looks good! I'm going to try these out!