Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by MjrPayne

  1. M

    CGO3 camera not connecting in cold

    Hi I've been flying Typhoon H without a camera in my back yard during this winter and it works OK. But when trying with the camera and temperature is around freezing point (or lower) then there's problem with WiFi connecting. If I turn the drone on indoors, camera wifi connects OK. But once...
  2. M

    Return Home Killed Motors Inflight

    Yes. I had it only couple of weeks and flew only few times before upgrade and no problems. And no problems after reinstalling upgrade. I just tested it after snow fall. The drone switch off if on the ground when turning RTH on. Then I tried taking it up about half a meter and flew it 2-3 meters...
  3. M

    Return Home Killed Motors Inflight

    This is what Yuneec EU said: "You are to near to the Typhoon H with you remote control, the H already thinks he is back home on the point and landed so it will switch of." So it seems that it's build in fail. But I got a new camera mount today and with it, I installed firmware again and now the...
  4. M

    Return Home Killed Motors Inflight

    http://h-elsner.mooo.com/mydat/Q500log2kml_en.pdf This document says that imu_status is an inertial measurement unit. So it's more like a movement monitor than a barometer. And the drone wasn't moving much, only drifted with light wind.
  5. M

    Return Home Killed Motors Inflight

    I thought it might be that when testing on the ground. But here's last lines on telemetry data of crashed flight showing that hight was 8 ft in the end. There's also remote data from those last seconds showing A01 and A02 change, which are controlled by the flight mode switch. Manual says: "B)...
  6. M

    Return Home Killed Motors Inflight

    I did calibrations but didn't clear flight data. And just tested after recalibrating accelerometer and compass, same thing: RTM killing motors. Here you see the test on video:
  7. M

    Return Home Killed Motors Inflight

    Took my H for flight first time after upgrading firmwares, both the controller and the drone, to the latest version. Taking off and rotating the drone worked OK but no response to a right stick controlling movements (Mode 2 selected). The drone then started to drift over nearby bushes. And...
  8. M

    New Pilot From Finland

    Hello World I got my Typhoon just before X-mas. Tried it few times. Hasn't beet too good flying weather in these weeks. Needs deicing for props to fly in below freezing point cloudy weather. Waiting for spring.