Recent content by MountainDroneTN

Sorry to hear. If your c23 isn’t beyond repair, would you consider rebuilding your H Plus? Not sure about the U.K., however, here in the States, there’s an eBay seller who has a Yuneec Typhoon H Plus “Dummy” Drone Kit with all the non-electric pieces you need, fuselage shell, landing legs, motor...

Post in thread 'Flipping while landing' Flipping while landing

Greetings from Tennessee. Do you fly, or seek information about, one of the great Yuneec products, if so which model(s) ?

Here are the led status codes from the Yuneec H920 manual. What position is your flight mode selection switch (S4) ? Caution, I did a "dumb move" with the S4 in the top position "smart mode."

Welcome to the forum. Sorry to read about your father-in-law. You've come to the right place for learning. I'm relatively new here, however, my first suggestion would be for you to earn a Trust Certificate from the FAA. https://www.faa.gov/uas/recreational_flyers/knowledge_test_updates

Hi and welcome to the forum. I'm somewhat new as well, so take this with a grain of salt. The remote controller with the overhead shot of trees is the ST16S (the one for your Typhoon H Plus).

The Intel RealSense Module on one.

That looks like the Typhoon H GPS module

Update, the panning issues went away when I re-attached the gps connector to the main board !

There should be a 5.8 flat antenna in your accessories box to also test as WFTDproject suggests.

That's a shame about the mushroom antenna. When the ST16s is placed into the case, that antenna folds 90 degrees nicely into a foam cutout . Regarding the screen's protective factory installed film, it's partial removal likely indicates that the supplier checked the controller several times, and...

with my st16s' firmware, I have to set the zoom before pushing record for videos

you're right, the zoom is a digital feature in the st16s

Drying oven is a better idea. Hey, the c23 is a beast. I cratered it into a forest floor, where it sat through 2 or 3 rainstorms for a week and after clearing messy rice and completing a messy soldering job, it functions. Records video, captures photos, zoom 1x through 8x, Tilt works...

After powering on the ST16s controller and powering on the drone (with the very same battery from my crash), I can report two things, the landing gear mechanisms have extended and the latch is still good (on the female side of the drone and even the male side of the same battery that I failed to...