Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by NICK WARD

  1. N

    Snapped Q500 4K antenna

    Steve The more I think about it the more I like the idea of this mod. If I mounted 2 at 90 degrees to each other to replace both do you think this would increase range.Searched the forum and most mention a further mod to the radio controller as well
  2. N

    Snapped Q500 4K antenna

    Many thanks for your help.I have seen on various videos on YouTube that the antenna’s are meant to be a specific length depending on the frequency which is 2.4 GHz.Going on this theory the pair that are fitted are too long.Im pondering over buying 2 of the correct length and fitting them.Last...
  3. N

    Snapped Q500 4K antenna

    As I live in UK I have found similar tails but they are listed as 10cm in length.The damaged antenna measured nearly 20cm from end to end .So wasn’t sure if I could use shorter ones.
  4. N

    Snapped Q500 4K antenna

    Had a bit of a disaster during the week had a leg fall off my drone.Amusing to say the least when landing, no so amusing to find dipole antenna snapped. Now managed to carefully take drone apart and pry damaged one off receiver board. Now do I need to go through Yuneec for replacement or are...
  5. N

    Video editing

    I'm currently playing about with editing of 4k video shot with my Q500 4K. Can anyone recommend software ware for joining clips and maybe a bit of slow mo.I tried AVS but quality of work looked rough, maybe wrong settings. Cheers Nick
  6. N

    firmware on my ST10+.

    Firstly I am sorry if this has been covered before but on searching forum, i cannot find answer. I have had a few attempts of updating my firmware on my ST10+ controller but the file is never visible to update. I have formatted card and loaded whole file but still nothing. Any idea what i'm...