Recent content by Olize

I have selected the new model in ST16 yes. The main problem I have is that the visual camera will not communicate anymore as also tested with VLC by wifi. The thermal picutre I got - think that means we definitely have a problem with the camera. Unfortunately, now no more flashing at the CGOET...

Thanks everybody for your help - I learned a lot about my new drone, unfortunately there was no success. But there is such a thing. I was grateful for every idea, now I'm trying to send in the drone by an RMA task. Unfortunately, the Customer Service of Yuneec in time 1:00 to 3:00 PM is really...

Thanks for this RMA link. I am thinking about sending the complete drone to Yuneec, not only the camera with gimble, because I don't want to loose the warranty. What do you think?

Is there anything possible by USB connection? Think not...

I have no idea how to persuade the drone to flash again. Maybe try to reset the camera again...?

Unfortunately not, only this Tyhpoon H with the CGO ET... Thats also an important case - will not loose warranty because this kit is very new. Maybe it is better to send whole aircraft to Yuneec for service - if I get contact to them... 😕

I tried to load H520 firmware this morning but same problem, camera wouldn't starting flash sequence . I understand your thinking first to revert to H520 firmware, then come back to original firmware - but don't know why camera do no more falshing

This is also new today that I have the information on Camera Version "Vnull" - sounds not so good Yesterday everything was N/A

seems it stays in the condition || two times amber (or bright yellow) and one time pink (or violet, whatever) no flashing possible anymore - don't know what is different now.

all free and ok - all is good and same like yesterday. At the moment the drone is running without ST16 and without SD card for a while just to ensure that all tasks in the system can be done

I cannot remember exactly, think it starts no more flashing since the first reset of the camera

During boot process LED is white, then when booting is finished and camera is online it starts flashing two times amber and one time violet - same when SD card is set or not set

Yes, ST is off - I am only starting the copter for flashing the camera - yesterday it was working well but maybe I never finished the update completely like mentioned in the document of WTFDproject ... after reboot the SD card should stay one more time to finish the installing

Now I am using a freshly charged batterie, so this cannot be the problem. I read that the battery should not be beyond 50% but i am not sure if this was corresponding with the camera or ST16 - it was only an idea. I'm going crazy why it's no longer possible to flash today

Did full formatting of the SD card and reset the camera by pressing the two dip switches . but no more flashing possible Don't know what is different then yesterday. Tried different SD cards