Hello Fellow Yuneec Pilot!
Join our free Yuneec community and remove this annoying banner!
Sign up

Recent content by Ozark

  1. O

    H motors not starting

    Problem solved. I got the new main board and flight controller board installed last night, got the H to bind to the ST16. Calibrated the compass between rain showers today and away she went. I did find out that in addition to the main board/fc board, my RealSense module was also bad. I don't...
  2. O

    H motors not starting

    No, the only other controller I have is a Spektrum DX5e for a plane that I have. I do have the Wizard controller that came with the H. I got it to bind, but it also displays the same issue with no motor start. In the absence of any other ideas, I'm going to replace the main board in the H and...
  3. O

    H motors not starting

    OK, here's the test shots.
  4. O

    H motors not starting

    You never know about the weather in the Ozarks. It cleared off this afternoon and I set the H and controller out in the back yard. Attached is the flightlog. Still no motors so no flight.
  5. O

    H motors not starting

    OK. I'll do that. We're having some pretty good rain right now so it'll be a couple of days (hopefully). I'll let you know as soon as I get the opportunity. Thanks again.
  6. O

    H motors not starting

    Thanks for taking the time to look. Won't the H fly without gps lock, with the gps turned off through the ST16? I did calibrate the compass several times and it appeared to take (H rebooted every time and the light changed to reflect the flight mode). I do have a "new to me" main board and...
  7. O

    H motors not starting

    Nope, the solders look good under magnification. Also, they all momentarily light when the drone boots up, including the red.
  8. O

    H motors not starting

    Log #21 is the one where it sat on the back porch.
  9. O

    H motors not starting

    Sorry about the delay guys. Family emergency has had me tied up for the past few days. I have checked the gps battery and it has 2.29 volts and rapidly counts up when I insert the battery, so it's good there. Also, no corrosion on the connector. I checked all of the connectors accessible...
  10. O

    H motors not starting

    Not in the ST16, but the flight control board inside the H. It is not one you can get to without partly disassembling the drone and removing the control board from the main board.
  11. O

    H motors not starting

    Quick question. What is purpose for the micro sd card socket on the bottom of the flight control board?
  12. O

    H motors not starting

    OK, Thanks. I'll get the multi meter out tomorrow and start checking voltages and plugs. I'll check back after I'm done and see if any more ideas are floated. I may try taking the RealSense off and see if that makes a difference. Thanks again for your time and thoughts.
  13. O

    H motors not starting

    OK, I do have the realsense module. It did not come with it, I added it. The unit will not go into IPS mode. I tried fast cycling the mode control and slow cycling.
  14. O

    H motors not starting

    OK, the LED is purple (3 flashes). Also, the H sounds a short beep every 30 seconds. Attached is a pic of the controller.
  15. O

    H motors not starting

    No, I have not. I will sit them both outside and get back with you in about 20. However, I did turn GPS off when trying to start it as well.
See more